Siemens SINUMERIK 840C Installation Instructions Manual page 587

7 Drive Machine Data (SIMODRIVE Drive MD)
7.4.3 Diagnosis/service MD (data description - as from SW 3)
11004
Default value
–
This machine data contains the low-order status bits (bits 0-15) of the cyclical status word at
the interface between SERVO and 611D.
Bit 0 DC link 1 reset
Bit 1 Parking axis setpoint
Bits 2-4 Assigned to or reserved for internal system functions
Bit 5 Function generator setpoint
Bit 6 Assigned to or reserved for internal system functions
Bit 7 - SW 4 Ramp-function generator setpoint
Bit 8 Assigned to or reserved for internal system functions
Bit 9 Ramp-function generator rapid stop setpoint
Bit 10 2nd torque limit setpoint
Bit 11 Speed setpoint smoothing setpoint
Bits 12-15 Assigned to or reserved for internal system functions
11005
Default value
–
This machine data contains the high-order status bits (bits 16-31) of the cyclical status word at
the interface between SERVO and 611D.
Bits 0-2 Set of set parameters
Bit 3 Motor selection setpoint
Bit 4 Assigned to or reserved for internal system functions
Bit 5 - SW 4 Motor switchover
Bit 6 Integrator inhibit setpoint
Bit 7 Pulse enable PLC setpoint
Bit 8 - SW 4 Current controller enable setpoint
Bit 9 Speed controller enable NC setpoint
7–172
Status word 1
Lower output limit Upper output limit
0000
Status word 2
Lower output limit Upper output limit
0000
©
Siemens AG 1992 All Rights Reserved
after ramp-up
of 611D link
Units
FFFF Hex
0 : on
1 : off
0 : on
1 : off
0 : on
1 : off
0 : off
1 : on
after ramp-up
of 611D link
Units
FFFF Hex
0 to 7
0 : star
1 : delta
0 : off
1 : on
6FC5197- AA50
SINUMERIK 840C (IA)
09.95
Active
Active
Dec