Table of Contents
Advertisement
flow: Minimum traffic during the idle timeout period in bytes. It ranges from 1 to 10240000 and defaults
to 10240.
Description
Use the idle-cut enable command to enable the idle cut function and set the relevant parameters. With
the idle cut function enabled for a domain, the device checks the traffic of each online user in the domain
at the idle timeout interval, and logs out any user in the domain whose traffic during the idle timeout
period is less than the specified minimum traffic.
Use the undo idle-cut enable command to restore the default.
By default, the function is disabled.
You can also set the idle timeout period on the server to make the server log out users whose traffic during
the idle timeout period is less than 10240 bytes, but your setting on the server takes effect only when you
disable the idle cut function on the device.
Related commands: domain.
Examples
# Enable the idle cut function and set the idle timeout period to 50 minutes and the traffic threshold to
1024 bytes for ISP domain test.
<Sysname> system-view
[Sysname] domain test
[Sysname-isp-test] idle-cut enable 50 1024
ip pool
Syntax
ip pool pool-number low-ip-address [ high-ip-address ]
undo ip pool pool-number
View
ISP domain view
Default level
2: System level
Parameters
pool-number: Address pool number, in the range 0 to 99.
low-ip-address and high-ip-address: Start and end IP addresses of the address pool. Up to 1024
addresses are allowed for an address pool. If you do not specify the end IP address, there is only one IP
address in the pool, which is the start IP address.
Description
Use the ip pool command to configure an address pool for assigning addresses to PPP users.
Use the undo ip pool command to delete an address pool.
By default, no IP address pool is configured for PPP users.
Related commands: ip pool.
Examples
# Configure the IP address pool 0 with the address range of 129.102.0.1 to 129.102.0.10.
77
Advertisement
Table of Contents
