o
6.1a Mounting the TMCF in a <180
Configuration (cont.)
6. Tighten and/or loosen the chains using the screw hooks to fine tune the angle between the blocks. The blocks
should fit snugly against the pipe.
Note: Make sure the blocks are in a common axial plane so the chains are not slanted. If the chains are slanted, the
slack will allow the fixture to move around.
7. Proceed to Mounting the Transducers into the TransFlection Mode Clamping Fixture - TMCF on page 37.
o
Figure 13 shows an example of a completed <180
installation without transducers.
End View
Side View
o
Figure 13: Completed <180
Installation without Transducers
C-PT Ultrasonic Flow Transducer Installation Guide
43