Siemens A53457 Installation & Maintenance page 15

2.6.29
Primary and Secondary DNS ......................................................................... 2-44
2.6.30
Default IP Gateway ........................................................................................ 2-46
2.6.31
WAG Site ID .................................................................................................. 2-48
2.6.32
Route RAW Echelon: No ................................................................................ 2-48
2.6.33
Route Unknown Outbound Echelon: No ......................................................... 2-49
2.6.34
Telnet Password: Disabled ............................................................................ 2-50
2.6.35
RS485 J1/J2 Jumper Detect: Enabled ........................................................... 2-50
3.0 OPERATION .................................................................................................... 3-1
3.1 INTRODUCTION ............................................................................................. 3-1
3.2 VIEWING THE STATUS .................................................................................. 3-2
3.2.1
Additional Status Information When WAG Configured for OSI ......................... 3-3
3.2.2
Genisys Status Report ..................................................................................... 3-4
3.3 VIEWING THE ROUTING TABLE .................................................................... 3-4
3.4 VIEWING MAC ADDRESSES.......................................................................... 3-5
3.5 VIEWING THE WAG CONFIGURATION ......................................................... 3-5
3.6 PERSISTENT SERIAL TUNNEL COMMAND .................................................. 3-6
3.7 CHANGING THE DIAGNOSTIC VERBOSITY LEVELS ................................... 3-7
3.8 SEND WINK REQUEST TO A WAG ................................................................ 3-7
3.9 SENDING A PING TO AN IP ADDRESS ......................................................... 3-8
3.10 SENDING A ROUTE PING REQUEST ............................................................ 3-8
3.11 TRACING AN INTERFACE .............................................................................. 3-9
3.12 SETTING THE CURRENT DATE .................................................................. 3-14
3.13 SETTING THE CURRENT TIME ................................................................... 3-14
3.14 UPLOADING/DOWNLOADING FILES ........................................................... 3-14
3.15 DATA/COMMAND MODE FROM A SERIAL INTERFACE ............................. 3-15
3.16 RETURNING THE SERIAL INTERFACE TO COMMAND MODE FROM A
TELNET SESSION ......................................................................................................... 3-15
3.17 RESTARTING THE WAG .............................................................................. 3-15
3.18 VIEWING SOFTWARE INFORMATION ........................................................ 3-16
3.19 REVIEWING THE LOGS ............................................................................... 3-16
3.20 LOG ENTRIES ............................................................................................... 3-18
3.21 CLEARING THE LOG .................................................................................... 3-27
3.22 REQIP ........................................................................................................... 3-28
3.23 WAGREPORT ............................................................................................... 3-28
3.24 TTIME ............................................................................................................ 3-29
3.25 REVISIONS ................................................................................................... 3-30
4.0 TROUBLESHOOTING ..................................................................................... 4-1
4.1 INTRODUCTION ............................................................................................. 4-1
Document No.: COM-00-05-16
Version: C.1
xv
June 2006, Revised June 2014