Table of Contents
Advertisement
INSTALLATION AND CONFIGURATION
6.
Prior to exiting the First Configuration Menu, select "Save changes then restart" to save
changes and restart the WAG.
2.6.22
Genisys Wait Poll Response
The Genisys wait poll response is used when the serial interface is configured for Genisys ATCS
Office. It designates the amount of time to wait before sending a Genisys poll.
The default value is 800ms.
To set the Genisys Wait Poll Response Time:
1.
On the Second Configuration Menu, select "Genisys wait poll response" Wait Timer to be set.
The Change Genisys Poll Response Wait Timer screen appears.
Figure 2-52. Change Genisys Poll Response Wait Timer Screen
2.
To keep the current timer setting, press ENTER. To change the timer setting, enter the new
value and then press ENTER. Entry can be any value from 20 to 65535.
The user will be returned to the Second Configuration Menu.
3.
Prior to exiting the First Configuration Menu, select "Save changes then restart" to save
changes and restart the WAG.
2.6.23
ATCS Retry Wait
The ATCS Retry Wait is used when the serial interface is configured for Genisys ATCS Office. It
designates the amount of time to wait before re-sending an ATCS message that has not been
acknowledged.
The default value is 800ms.
To set the ATCS Retry Timeout:
1.
On the Second Configuration Menu, select "ATCS Retry wait" Timer to be set. The Change
ATCS Retry Timeout screen (see Figure 2-53) appears.
Document No.: COM-00-05-16
Version: C.1
2-38
June 2006, Revised June 2014
Advertisement
Table of Contents
Troubleshooting
