Chapter 4. Using The Outputs, Alarms And Logger Menus; Setting Up The Outputs; Configuring An Output - GE moisture.iq User Manual

Chapter 4. Using the Outputs, Alarms and Logger Menus

4.1 Setting Up the Outputs

4.1.1 Configuring an Output

Note: An active output is indicated by a "Play" symbol, and the alarm selected for editing is highlighted in
yellow. A dashed border around an output indicates that the channel is not installed.
The moisture.IQ features two isolated analog outputs (A and B) for each of its six channels. To configure these
outputs, refer to the menu map in Figure 77 on page 110 and tap the Outputs button on the right side of the
main touch screen to open a screen similar to that shown in Figure 43 below.
1. Tap the button for the desired Channel (1-6) and Output ( A or B ).
2. In the Measurement Selection section, tap the Mode, Unit and Type (Current or Voltage) buttons to enter
the desired settings for the output. (For available modes and units, refer to Table 8 on page 61.)
3. Tap the Zero box and enter the zero value via the keypad.
4. Tap the Span box and enter the span value via the keypad.
5. Tap the Check button to save your settings.
moisture.IQ User's Manual
Figure 43: Outputs Selection Screen
Chapter 4. Using the Outputs, Alarms and Logger Menus
49