9. Remove the two screws, then remove the rack angle.
10. Remove the convex portions of the DP board assembly
from the hook portions of the frame.
11. Remove the four screws, then remove the DP-455
board from the DP case.
12. Disconnect the harness (DP) from the connector
(CN101) on the DP-455 board.
13. To install, reverse the removal procedure.
3-20 (E)
B4 x 6
Rack angle
Hook portions of frame
Convex portions
DP board assembly
Harness (DP)
CN101
DP case
BVTP3 x 8
DP-455 board
LMT-300