Sony LMT-300 Service Manual page 11

10. Loosen the two screws (with stopper), then remove the front panel.
n
When attaching the front panel, tighten the screws (with stopper) using the screwdriver.
Tightening torque: 0.8 N.m (8.16 kgf.cm)
11. Disconnect the harness from the STATUS LIGHT connector in the front panel.
12. Disconnect the all cables connecting to this unit.
13. Remove the HDD unit. (Refer to the LMT-300 installation manual.)
14. Remove the four screws (B5 x 12).
15. Pull out this unit from SRX-R320.
STATUS LIGHT
connector
SRX-R320
16. To install, reverse the removal procedure.
LMT-300
Harness
B5 x 12
LMT-300
PSW4 x 35
(with stopper)
B5 x 12
PSW4 x 35
(with stopper)
Front panel
1-3 (E)