Installing The Canopen Module For Sizes Fx, Gx - Siemens MICROMASTER 420 Operating Instructions Manual

Issue 01/05
4.3

Installing the CANopen module for Sizes FX, GX

WARNING
The drive converter/drive inverter must be powered-down (brought into a no-
voltage condition) before the CANopen communications module is installed or
withdrawn from a MICROMASTER 430/440.
Installing the communications module
For these Sizes, the CANopen communications module is installed in the drive
converter/drive inverter housing.
To do this, the panel must be removed.
Fig. 4-4 Installing the communications module for MICROMASTER 4, Sizes FX, GX
The communications module is installed essentially the same as for Size A (refer to
Section 4.1). Then re-locate the covers on the drive converter/drive inverter.
CANopen Option Module Operating Instructions
6SE6400-5BC00-0BP0
Information for the CANopen master
69