Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
T
O REPLACE THE GRAPHICS BOARD
1. Insert the graphics board into the chassis.
Tilt the board to fit the mounting bracket in the chassis slot corresponding to the PCI-E2 x8
connector on the motherboard.
2. Reseat the graphics board by installing it in the PCI-E2 x8 connector on the motherboard
(see
Figure 26 on page
The component side of the board should be facing down toward the base of the chassis. The
board connector is keyed to fit only one way.
When reseating the board, be careful not to disturb any motherboard cables that are installed
nearby.
3. Replace the bracket screw to the mounting bracket in the back panel slot.
4. If you removed the metal port cover from the board mounting bracket earlier, reinstall the
cover now.
Reinstall the cover using the two screws that you removed earlier.
5. Replace the bracket cover plate to the back panel (see
6. Reassemble the imagePRESS Server and verify its functionality (see
76).
Figure 13 on page
54).
page
130).
70
Advertisement
Table of Contents
