Table of Contents
Advertisement
S
Front fan
The following procedures describe how to remove and replace the front fan. The front fan is
secured to the chassis by a plastic mounting bracket.
T
O REMOVE THE FRONT FAN
1. Shut down the imagePRESS Server, remove all cables from the back, and then open the
system (see
In order to access the fan, you must remove the left panel.
2. Detach the 3-pin fan cable connector from its connector on the motherboard.
3. Remove the fan assembly from the chassis (see
Press to unlock the latches on the fan mounting bracket, and lift the assembly out of the
chassis. When removing the fan assembly, be careful not to disturb or disconnect any cables
that are installed nearby.
Latch (1 of 2)
Slot for bracket tab
(1 of 3)
F
IGURE
P
ERVICE
ROCEDURES
Figure on page
37:
Removing/replacing the front fan assembly
59).
Figure
37).
Fan assembly
Board guide
108
Advertisement
Table of Contents
