Table of Contents
Advertisement
Error messages and conditions
Symptom
4 beeps, followed by 3 beeps,
followed by 1 beep, followed
by 2 beeps
T
ROUBLESHOOTING
To learn possible causes and solutions for a specific error message or condition, find the
symptom in
Table 6
and perform the appropriate suggested actions.
For errors or conditions that are described as occurring in a specific stage of the boot up
process, see
"Normal startup sequence" on page 148
Do not install a new HDD and a new motherboard in the imagePRESS Server at the same
time. If you suspect that the imagePRESS Server needs a new HDD and a new motherboard,
first install the new HDD and install system software. Then install a new motherboard and
perform the system update procedure (see
If replacing a specified component does not correct the problem, make sure that you install
the old component back in the imagePRESS Server.
imagePRESS Server error messages and conditions
T
6:
ABLE
Possible cause
Beep codes during startup
Missing, unmatched, incorrect,
or faulty DIMMs
for what normally occurs at each stage.
"Replacing the motherboard" on page
Suggested action
1. Check for missing DIMMs and reseat the DIMMs to remove
any oxidation on the connectors (see
2. If the problem persists, test the DIMMs by removing
all DIMMs except for the one installed in J11, and
reboot the system.
If the system boots to Idle, install a different DIMM in
J11 and reboot the system. Continue to install a
different DIMM in the socket and reboot the system
until the system fails to reach Idle. The last DIMM that
you installed may be faulty and should be replaced.
N
:
If the system fails to reach Idle with each DIMM
OTE
installed in J11, the DIMM socket may be faulty and you
may need to replace the motherboard.
149
83).
page
99).
Advertisement
Table of Contents
