Frame R4 - ABB ACS560 Hardware Manual

￭ Frame R4...R8
The layout of a frame R6 drive is presented below. The frame sizes R7...R8 is similar but
have a different structure.
1
3
3
1
1 Installation point (2 points on the top and 2 points
on the bottom of the frame body)
2 Cover plate
3 Lifting hole
4 Basic control panel
5 Control panel connection
6 CCA-01 interface
7
For LED of normal power supply and failure, see
section LEDs (page
8
I/O connection. See section
connection terminals, frames R6...R8 (page
9 Cable bundle installation position of I/O cable
10 Mechanical support clamp of I/O cable
5
4
7
2
104).
External control
31).
Operation principle and hardware description 27
12
11
17
6
8
9
12
10
16
10
13
15
14
PE
11 Voltage dependent resistor ground screw (VAR),
arranged below the control tray.
12 Two EMC filter ground screws, one arranged
below the control tray bracket and the other ar-
ranged on the left and above the protective cov-
er.
13 Protective cover. Below the protective cover: in-
put voltage connection (L1, L2, L3), motor con-
nection (T1/U, T2/V, T3/W) and DC connection
(UDC+, UDC-).
14 PE connection (power line)
15 Earthing connection (motor)
16 A primary fan
17 Auxiliary fan