Brake Resistor Connection Data For Frames R0; Control Connection Data - ABB ACS560 Hardware Manual

Frame size Maximum motor cable length, 4 kHz
m
R7 150
R8 150
1)
See the terms in section
external EMC filter to meet the category 2 standards.
Note 2: Radiated emissions are according to C3 with an internal EMC filter.
Note 3: The internal EMC filter must be connected.
Note 4: Radiated and conducted emissions are according to category C3 with an internal
filter and these cable lengths.
Note 5: Categories C1 and C2 meet requirements for connecting equipment to the public
low-voltage networks.
Brake resistor connection data for frames R0...R3
Short-circuit protection
(IEC/EN 61800-5-1, IEC 6439-
1)

Control connection data

External power supply
+24 V DC output
(Term. 10)
Digital inputs DI1...DI6
(Term. 13...18)
Relay outputs RO1...RO3
(Term. 19...27)
Analog inputs AI1 and AI2
(Term. 2 and 5)
Definitions (page 129). Applicable for frames R4...R8. Frames R0...R2 require
The brake resistor output is conditionally short-circuit proof by IEC/EN 61800-
5-1 and UL 508C. Rated conditional short-circuit current as defined in IEC
6439-1.
Maximum power:
Frames size R0...R5: (Without external power supply)
Frames size R6...R8 : 36W, 1.50A (24V AC/DC±10%, standard configuration)
Total load capacity of the outputs is 6.0W (250mA/24V) minus the power
taken by the option modules installed on the board.
Input type: NPN/PNP
DI1...DI5(Terminal 13...17)
12/24V DC logic levels: "0" < 4V. "1" > 8V
R : 2.68kOhm
in
Hardware filtering: 0.04ms, digital filtering: 2ms sampling
DI6 (terminal 18)
Can be used as a digital or frequency input.
12/24V DC logic levels: "0" < 3V. "1" > 8V
R : 6.2kOhm
in
Max. frequency 16kHz
Symmetrical signal (duty cycle D = 0.50)
250 V AC / 30 V DC, 2 A
a dip switch or see section
Current input: 0(4)...20 mA, R
Voltage input: 0(2)...10 V, R
Inaccuracy: typical ±1%, max. ±1.5% of full scale
ft
492
492
Switches (page 82).
: 100 ohm
in
: > 200 kohm
in
Technical data 121