Replacing The Auxiliary Cooling Fan, Frames R6 - ABB ACS560 Hardware Manual

3. Pull the fan mounting plate down from the side edge.
4. Unplug fan power supply wires from the drive.
5. Lift the fan mounting plate off.
102 Maintenance and hardware diagnostics
6. Remove the fan from the mounting plate.
7. Install the new fans in reverse order.
7. Install the new fans in reverse order.
6
￭ Replacing the auxiliary cooling fan, frames R6...R8
WARNING!
Obey the instructions in chapter
instructions can cause physical injury or death, or damage to the equipment.
1. Stop the drive and disconnect it from the power line. Wait for 5 minutes and then make
sure by measuring that there is no voltage. See section
work (page 13)
2. Remove the front cover (see
R5...R8 (page
3. Unplug fan power supply wires from the drive.
4. Release the retaining clips.
5. Lift the fan off.
2
before you start the work.
Installing the drive vertically, frames size
46)).
Safety instructions (page
Precautions before electrical
3
11). Ignoring the