Siemens SIPROTEC 5 Manual page 30

Introduction
1.5 Scope of Functions
Identifying the Measuring Points
The measuring points can be assigned and established for example as in the
data acquisition requires, in addition to the selection of the measuring point, also a definition and establish-
ment of the evaluation criteria at the individual measuring points. There the monitoring of the Network
Quality is a combination of data acquisition techniques, which are classified according to purpose or use.
[dwnetzve-161012-01.tif, 1, en_US]
Figure 1-3
Table 1-1
No. Measuring Points
1 Infeed (line or transformer)
2 Power generation/decentral power
generation
3 Forwarding, distribution system
4 Forwarding, infeed (line or trans-
former)
5 Forwarding, distribution system
6 Distribution, infeed (line or trans-
former)
7 Power distribution, consumers
30
General Display of the Measuring Points
Assignment of measuring points
Location
Possible busbars
Busbars, transformers or generator connection
Busbars (for example, if the busbar belongs to the transmis-
sion company and is run by it.)
Decentral line connection (for example, if the line belongs to
the transmission company and is run by it.)
Transformer secondary circuit or cable for adjacent trans-
former station
Distribution transformer
Distribution transformers (for example, if the transformer
belongs to the transmission company and is run by it.)
C53000-G5040-C018-5, Edition 11.2017
Figure 1-3. The fault record or PQ
SIPROTEC 5, Fault Recorder, Manual