Memory Guidelines; Accessory Board Guidelines; Technical Specifications; Environment - HP server rx4610 Service Manual

Chapter 2

Memory Guidelines

Each Memory Board can support from 1 GB to 32 GB. The server supports up to 64 GB of system memory.
•
Use only HP DIMMs, which are 3.3V, 168-pin, PC100, buffered SDRAM DIMMs in 256 MB, 512
MB, or 1 GB modules.
•
DIMMs must be installed in the order indicated by the numbered slots on the memory board in
groups of four. Verify that the same size DIMM is used in any given row by using the same HP
part number.
•
To ensure optimum performance when two boards are installed, the memory on each board
should be equal, that is, the DIMMs must be the same type and quantity.
•
Ensure both latches close on the DIMM when completely installed.
•
When handling DIMMs, observe anti-static precautions to avoid damage.

Accessory Board Guidelines

Tested PCI Boards
For a list of tested PCI boards, check for compatibility under the Hardware Tested Products list for the HP
Server rx4610 under the Service and Support topic for the specific NOS used in the server at HP's web site:
http://www.hp.com/
CAUTION

Technical Specifications

The specifications listed below vary if you install a mass storage device in your server that has more
stringent environmental limits. Ensure the operating environment for your server is suitable for all of the mass
storage devices being used.

Environment

Temperature
Operating
Non-operating
Humidity
Operating
Non-operating
Some accessory board outputs may exceed U.S. National Electrical code (NFPA
70) Class 2 or limited power source limits and must use appropriate inter-connecting
cabling in accordance with the National Electrical Code. (All HP boards comply with
Class 2.)
5° to 35° C (41° to 95° F)
-40° to +65° C (-40° to +149° F)
20% to 80% relative humidity, non-condensing
5% to 95% relative humidity, non-condensing
System Information
10