Installing The Sideplane Board; Pci Hot Plug Led Board; Removing The Pci Hot Plug Led Board - HP server rx4610 Service Manual

Chapter 6

Installing the Sideplane Board

To install the Sideplane board, complete the following steps:
1. Observe all safety and ESD precautions for handling electronic components.
2. Install the Sideplane on to the mounting plate by tightening the two mounting plate screws.
3. Lower the board into the side of the chassis, and slide it toward the rear of the chassis back into
position. The front lower corner of the board is the rotation point you should use when
positioning the board into place.
4. Tighten the captive thumbscrews on Sideplane to secure it to the chassis.
5. Reinstall the Power Distribution Board (T-Docking) as described in "Installing the Power
Distribution Board (T-Docking)".
6. Reinstall the I/O Baseboard as described in "Installing the I/O Baseboard".
7. Reinstall the Processor/Memory Complex.

PCI Hot Plug LED Board

The PCI Hot Plug LED Board resides just on the inside of the top rear of the chassis. This board enables
PCI hot plug boards to be plugged into and out of the system without it being shut down.

Removing the PCI Hot Plug LED Board

To remove the PCI Hot Plug LED Board, complete the following procedure:
1. Observe all safety and ESD precautions for handling electronic components.
2. Turn off all peripheral devices connected to the system.
3. Power down the server by pressing and holding the Power button on the Front Control Panel.
You may have to hold the Power button down for several seconds. Removing the power cords
ensures that the server is not under standby power.
WARNING
4. Pull the chassis out of the rack as far as it will go.
5. Loosen the two thumbscrews in the back of the chassis that secure the rear cover.
6. Lift the rear cover to expose the non-hot plug PCI adapter board cover.
Figure 53. Remove the Sideplane
Make sure that the rack is anchored securely, so it will not tip when the server
chassis is extended.
Replacing Parts
126