Philips LTC 2622/90 Installation Instruction page 38

LTC 2600 Series
Status Display: The status display indicators are located on either side of the numeric display at the top of the
keyboard. On the right side of the numeric display, there are three status display indicators: Camera, Cameo, and
Pound. On the left side of the numeric display, there are six status display indicators:VCR, Monitor B, Sequence,
Allplex, Record, and Playback.
LED Display: Certain keys have an LED indicator to light up or flash to indicate that the function is either
enabled or in the alarm state.The keys that are tied to an LED are: Cameras 1 – 16, ALT, ACT, and ALM.The
operation of these LEDs is identical to those on the front panel of the multiplexer.
Numeric Keypad:The numeric keypad is designed to serve three purposes: selecting cameras, selecting cameos,
and numeric entry.The operation of the numeric keypad keys is identical to the multiplexer front panel.
Additional Function Keys:The system keyboards contain additional function keys not available on the front panel
of the multiplexer.They are as follows:
Allplex Selection - (Requires two-key combination: "Allplex") then #, then SELECT
Allplex number.The system accepts only valid Allplex numbers 1 through 30.
SET - Set is a pre-position function of an AutoDome or Pan/Tilt and Zoom lens.
Press SET to record a preset scene at remote camera site. (Up to 99 presets can be recorded for Philip's R/D
or AutoDome.) Set a preset function of a camera: Press "Full" then camera numbers (1-16). Use the joystick to
move the camera to the scene that you want to store, then press SET, # (1-99), then SELECT
SHOT - Press SHOT to call up a preset scene at remote camera site.
Call up a preset function of a camera: Press SHOT, # (1-99), then SELECT
AUX+ - Press AUX+ to select a receiver/driver auxiliary function at the camera location.
AUX- - Press AUX- to deselect any receiver/driver auxiliary functions currently in the "ON" state.
(Note: Refer to Philip's R/D or AutoDome Instruction Manual for Auxiliary function)
Multikey Access Functions: Simultaneously press the multiple keys listed to enable the function as described.
QUAD + CAMEO + Allplex:
QUAD + CAMEO + ALT:
QUAD+ ENTER+ ENLARGE: Set the keyboard user level to FULL ACCESS.
VCR Control
VCR + SELECT - To toggle the VCR CONTROL mode ON and OFF.
Use the following keys for VCR functions:
VCR Function
RECORD
PLAYBACK
STOP
PAUSE
FAST FORWARD
FAST REWIND
Allplex + SELECT: To switch control to another multiplexer.
Allplex + ALT:
Pan/Tilt Control: For Pan/Tilt controllable units, operation of the joystick (LTC 2602) or four directional keys
(LTC 2601) will make the selected camera tilt up or down, pan left or right, or move diagonally.
Lens Control:The joystick of the LTC 2602 keyboard is used to provide zoom control by rotating the knob in
either a clockwise or counterclockwise direction.The LTC 2601 provides two additional keys required to operate
the zoom functions. Push buttons are included with both keyboards to control focus near or far and to open or
close the iris (on applicable lenses).
Set the keyboard user level to NO ACCESS.
Set the keyboard user level to LIMITED ACCESS.
Press Key
REC/SET
PLAY/SHOT
ZOOM
FREEZE
CAMEO/>
FULL/<
To Enter and Exit the keyboard TEST mode.
.
39
Section 7 Enhanced Operation
key to select new
.