Philips LTC 2622/90 Installation Instruction page 36

LTC 2600 Series
Set the Search Time as shown below:
Set the Search Date as shown below:
To start the search:
• Select the quick key sequence "ALT-1-VCR-PLAY," and the playback search window menu will be displayed.
• Set the required date/time (Note the current playback time will appear as a default).
• Select START SEARCH. The search display window will appear showing the desired time, the last date and time
read from the recorded tape, and the VCR status.
• The multiplexer will automatically forward/rewind the tape to the required time/date.
• When the required time/date is found, the message "Search Completed" will be displayed.The beeper will
sound, and after 3 seconds, the initial playback screen will be displayed on MON A.
• If the multiplexer cannot find the required time/date, it will prompt the user and discontinue the search, returning to
the initial playback screen.
• To abort the search at any time, press the ZOOM
SEARCH TIME
SETUP 01
This is the time of the
picture to be viewed from the
VCR tape.
23:06:00
^
Move Cursor:<>
Default:FREEZE Edit:^v
Save:SELECT Exit:ZOOM
SEARCH DATE
This is the date of the
Picture to be viewed from
the VCR tape.
12/11/2001
^
Move Cursor:<>
Default:FREEZE Edit:^v
Save:SELECT Exit:ZOOM
key.
SEARCHING...
11:30:00 07/16/99
CANCEL SEARCH: ZOOM
10:35:26 07/16/99 PB
37
Section 7 Enhanced Operation