Table of Contents
Advertisement
Chapter 4. Using the Outputs, Alarms and Logger Menus
4.1.4 Setting the Output Range Error Response
A Range Error can occur when a measured value is within the capacity of the analyzer, but it exceeds the calibration
range of the probe. They can be either
The moisture.IQ indicates Range Errors with an
measurements of the same mode. For example, if a dew point measurement is
Over Range.
also be
If multiple Range Errors occur simultaneously, the moisture.IQ responds to them in the following
Oxygen Errors
Moisture Errors
order:
,
Complete the following steps to configure the range error response of the selected output:
1. Tap the desired
to Figure 46 below.
2. Set the output to be driven either
Ignore
Range errors (
3. Set the output to be driven either
Ignore
Range errors (
Save
4. Tap the
button to keep the new settings or tap the
50
Under Range
Temperature Errors
,
Channel (1-6)
Output
and
Figure 46: Range Error Setup Screen - Output Response
High
on Under Range errors,
is the default setting).
High
on Over Range errors,
is the default setting).
Over Range
or
errors.
Over Range
Under Range
or
Pressure Errors.
and then
A
B
(
or
), and then tap the
Low
Low
Cancel
button to keep the previous settings.
message.The error condition applies to all
Over Range
, then moisture in ppMv will
Range Error
button to open a screen similar
on Under Range errors or to
on Over Range errors or to
moisture.IQ User's Guide
Ignore
Under
Ignore
Over
Advertisement
Table of Contents
