Switching Between Screen Layouts - Huawei TE40 Administrator's Manual

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
Parameter
Noise
reduction
Set output
resolution
automaticall
y
Video
resolution
Image
inversion
----End

4.2.5 Switching Between Screen Layouts

By adjusting the screen layout, you can view multiple videos on the same display device.
Only the main output port supports combined picture output. For details, see
4.2.1 Configuring Video
To adjust the screen layout, use either of the following methods:

Issue 01 (2013-09-30)
Description
 User defined: delivers video with
custom settings. After you select this
option, you can set the following
parameters.
− Aperture: sharpens video edges
and contours to preserve the
impression of clarity and fine
details. Over-sharpening will
make video less realistic.
− Brightness: specifies the video
output level that changes the
brightness of the video displayed
on the monitor.
Hue: adjusts the video color.
−
− Saturation: adjusts the gray scale
of each color. The higher the
saturation, the brighter a color.
Removes noise artifacts from video. A
larger value causes the video to have less
noise but detail may also be lost.
Specifies whether the camera
automatically sets the video output
resolution.
Specifies the video output resolution for
the camera. This parameter is available
only when Set output resolution
automatically is set to Disable.
Specifies whether the video input from
the camera is rotated by 180 degrees.
When the camera is hung, set this
parameter to Enable.
Output.
When the endpoint is not in use in a conference, press
switch between the Picture in Picture (PiP) and two-pane modes. When the endpoint is in
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Display Device and Camera
Setting
The default value is Low.
The default value is Disable.
The default value is 1080p
60Hz.
The default value is Disable.
Table 4-8
on the remote control to
in
49