Huawei TE40 Administrator's Manual page 30

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
Parameter
Gateway
address
IPv6
Subnet
prefix length
PPPoE
Dialing
mode
LAN2
Local IP
address
Subnet mask
Issue 01 (2013-09-30)
Description
Specifies the gateway address that
corresponds to the endpoint IP address.
If you select IPv6, you must also set
Connection type, Local IP address,
Subnet prefix length, and Gateway
address.
Specifies the number of the digit 1 in a
subnet mask that is converted into binary
mode.
Specifies whether the endpoint accesses
broadband networks using dial-up
connections.
NOTE
If you set this parameter to Enable, you must
also set Dialing mode, User name, and
Password.
Specifies the dial-up connection mode.
The dial-up process complies with the
Point-to-Point Protocol over Ethernet
(PPPoE) protocol. To use a dial-up
connection, in User name and
Password enter the user name and
password that are provided by your
broadband access service provider.
 Auto: When the endpoint starts, it
automatically sets up a dial-up
connection over the IP network. If the
dial-up service is not free of charge,
charging starts when the dial-up
connection is established.
 Manual: The endpoint uses the
dial-up program to access To set up a
PPPoE dial-up connection, choose
Advanced > Utilities > PPPoE
Dialing > Connect.
Specifies the alternate IP address of the
endpoint. This IP address cannot be in
the same network segment as Local IP
address (described in the LAN1 section
in this table) or the IP address of the
gatekeeper (GK) server.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Network
Setting
Examples:

IPv4: 192.168.1.1

IPv6: 2000:0:0:0:200:55:0:1
Obtain the gateway address
from the network administrator.
This parameter is not selected
by default.
The default value is 0.
The default value is Disable.
The default value is Auto.
No default value is set for this
parameter.
Obtain the IP address from the
network administrator.
22