Huawei TE40 Administrator's Manual page 156

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide



On the endpoint web interface, choose System Settings > Network and click the SNMP
Settings tab. Set the SNMP parameters described in
Table 13-4 SNMP parameters
Parameter
Enable
SNMP
Get
community
name
Set
community
name
Trap
community
name
Trap server
address 1
Trap server
address 2
Trap server
address 3
Issue 01 (2013-09-30)
Checks endpoint alarms.
Backs up and restores endpoint settings.
Upgrades the endpoint online.
Description
Specifies whether the videoconferencing
network management system uses SNMP
to manage your endpoint.
NOTE
If you set this parameter to Enable, you must
set other SNMP parameters.
Specifies the read-only SNMP
community name.
Specifies the read-write SNMP
community name.
Specifies the trap community name.
Specify the IP address to which your
endpoint sends traps, namely, the IP
address of the computer where the
videoconferencing network management
system server is installed.
NOTE
A trap is an unrequested message that a
managed device (for example, an endpoint)
sends to a trap server (for example, the SMC)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 Feature Configuration
Table 13-4.
Setting
The default value is Enable.
The default value is
Change_Me.
Set this parameter to the value
defined on the
videoconferencing network
management system.
The value is a string of 1 to 32
characters.
The default value is
Change_Me.
Set this parameter to the value
defined on the
videoconferencing network
management system.
The value is a string of 1 to 32
characters.
The default value is
Change_Me.
Set this parameter to the value
defined on the
videoconferencing network
management system.
The value is a string of 1 to 32
characters.
No default value is set for this
parameter.
You can leave this parameter
blank.
148