Preparation On The Day Of Flight; Transporting Procedure - Yamaha RMAX Type II G Unit Operation Manual

Preparation on the Day of Flight

Transporting Procedure

G To prevent burns, do not touch the muffler,
which could be very hot after a flight.
G Exercise caution to avoid poking your eyes
with the antenna or the like.
NOTICE
G Make sure to remove the chemical tank for
the sprayer. If a liquid sprayer is installed,
fold the boom before transporting the heli-
copter. See the operation manual of the
sprayer for details.
G Do not allow the main rotor blade to come
in contact with the ground or with any
objects in the area, as this could lead to
equipment damage.
G Do not hold the helicopter by the tail body,
tail cover, radiator, or antenna, as this
could lead to equipment damage.
G Make sure to turn OFF the main switch
before moving the helicopter. Otherwise,
the shocks from the movement will trans-
fer onto the sensors, and could cause the
helicopter to operate erroneously.
G To transport the helicopter by rolling it on
the ground, attach the transport wheels
(sold separately).
Installing and Removing Transport Wheels (sold separately)
To transport the helicopter by rolling it on the
ground, transport wheels must be attached to the
front of the runners. The installation (or removal) of
the wheels is done by 2 persons as follows:
1 Use your hand to lower the stone guard to raise
the front end.
2 Install (or remove) the transport wheels in the
recess located between the wheel and pipe in
the front of the runner.
WARNING
Pre-Flight Preparation and Inspection
Chemical Tank
Boom
Runner
Transport Wheel
Stone
Guard
4-6