®
ABB i-bus
KNX
Commissioning
3.2.3.1
X Output: State parameter window
Settings for the status response of output X are made in this window. With the DG/S 2.64.1.1, the two
DALI outputs are mutually independent and can each be parametrized differently.
The status response of the individual ballast and group can be set in the respective ballast/group in the
Group x status and Ballast x status parameter windows. The ballast/group template window does not apply
to the output.
Note
If a ballast stops signaling on the DALI or has a lamp fault, its switch status changes to OFF and its
brightness value status to 0. This is also taken into account when the system calculates the status
values for the DALI output.
52 2CDC507164D0201 | DG/S x.64.1.1