Parameter Window A: Monitor Voltage - ABB i-bus KNX Product Manual


ABB i-bus KNX
Commissioning
3.2.5.8.3

Parameter window A: Monitor voltage

In parameter window A: Monitor voltage, the parameters and the communication objects for the detection
and monitoring of the voltage of output A are enabled.
Send "Voltage" after a change
Options:
•
yes: The value of the communication object Voltage is sent after a change. The following parameter
appears:
Send "Voltage" on request
Options:
•
yes: The value of the communication object Voltage is sent when a telegram is received on the com-
munication object Request power values. This communication object is enabled in the parameter win-
dow General, page 29 .
Send "Voltage" cyclically
Options:
•
yes: The value of the communication object Voltage is sent cyclically. The setting of the cycle time is
undertaken in parameter window General, page 29 (parameter Cycle time for power values).
Cycle time and request objects are set
on "General"
<−−− NOTE
86 2CDC 505 084 D0203 | SE/S 3.16.1
no
yes
Send "Voltage" when
+/- V [1...265]
Options: 1...5...265
This parameter determines which changes of the value of the communication object Voltage are
sent.
no
yes
no
yes