ABB i-bus KNX Product Manual page 10


ABB i-bus KNX
Device technology
4)
Accuracy
Starting current
3)
Relay switching times
Connections
Operating and display elements
Enclosure
Safety class
Insulation category
KNX safety extra low voltage
Temperature range
Ambient conditions
Design
Weight
Installation
Mounting position
Housing/colour
Approvals
CE mark
1)
Further information concerning electronic endurance to IEC 60 947-4-1 can be found at:
2)
The maximum peak inrush current may not be exceeded, see
3)
The specifications apply only after the bus voltage has been applied to the device for at least 30 seconds. Typical delay of the relay is approx. 20
ms.
4)
The stated values apply only if no DC components are present. A DC component causes additional distortion of the measurement result.
8 2CDC 505 084 D0203 | SE/S 3.16.1
Active consumption/active power (250...500 mA) ± 6 % measuring value
Active consumption/active power (500 mA... 5 A) ± 3 % measuring value
Active consumption/active power (5...20 A)
Current (0.025...20 A)
Voltage (95...265 V)
Frequency (45...65 Hz)
25 mA
Maximum relay position changes
per output per minute if all
relays are switched simultaneously.
The position changes should be distributed
evenly
over the minute.
Maximum relay position changes
per output per minute if only
one relay is switched.
KNX
Load current circuits (1 terminal per contact)
Ferrules without/with plastic sleeves
TWIN ferrules
Tightening torque
Button/LED
Switch position display
IP 20
II, in the installed state
Overvoltage category
Pollution degree
SELV 24 V DC
Operation
Storage
Transport
Maximum air humidity
Modular installation device (MDRC)
Dimensions
Mounting width in space units (modules at 18
mm)
Mounting depth in mm
in kg
On 35 mm mounting rail
As required
Plastic housing, grey
KNX to EN 50 090-1, -2
In accordance with the EMC and Low Voltage
Directive
Lamp load output, page 9.
± 2 % measuring value
± 1 % of actual value and ± 10 mA
± 1 % of actual value
± 1 % of actual value
15
60
Via bus connection terminals
0.8 mm Ø, single core
Universal head screw terminal (PZ 1)
2
0.2... 4 mm stranded, 2 x 0.2...2.5 mm
2
0.2... 6 mm solid, 2 x 0.2...4 mm
2
0.25...2.5/4 mm
2
0.5...2.5 mm
Contact pin length min. 10 mm
Maximum 0.8 Nm
For assignment of the physical address
Relay operating element
To EN 60 529
To EN 61 140
III to EN 60 664-1
2 to EN 60 664-1
-5 °C...+45 °C
-25 °C...+55 °C
-25 °C...+70 °C
93 %, no condensation allowed
Pro M modular installation device
90 x 72 x 64.5 mm (H x W x D)
4
64.5
0.26
To EN 60 715
Certificate
AC1, AC3, AX, C-Load specifications, page 15
2
2