ABB i-bus KNX Product Manual page 139


ABB i-bus KNX
Planning and application
Load control master
Behaviour with:
Communication objects:
Receive power value X
Communication object:
Deactivate load control
Evaluation
Load limit
Bus voltage recovery Download
Power values are lost and Power values are retained.
set with the value 0.
The response can be If the function Load control
parameterized master was active before
the download, it will be
•
active
reactivated after a down-
•
not active
load. If the function was
not active before a
•
unchanged.
download, it will not be
activate after a download.
The power values will be As with bus voltage
requested via Value Read. recovery
Evaluation starts after an
evaluation delay of 10 s.
The active load limit before Load limit can be
changed = yes, object
bus voltage failure will be
set again after bus voltage writable
recovery.
The parameter Overwrite
load limit with download or
ETS reset determines
whether the parameter
values are accepted.
Load limit can be
changed = yes, 4 values
selectable
The parameter Active load
limit after download ETS
reset determines the limit
to be set.
ETS reset Full download / applica-
tion update
As with bus voltage As with bus voltage
recovery recovery
Is set to the value 0. Is set to the value 0.
As with bus voltage As with bus voltage
recovery recovery
As with download Load limit can be
changed = yes, object
writable
The parameter Overwrite
load limit with download or
ETS reset determines
whether the parameter
values are accepted.
Load limit can be
changed = yes, 4 values
selectable
Load limit 1 is active.
SE/S 3.16.1 | 2CDC 505 084 D0203 137