ABB i-bus
KNX
Commissioning
The following status messages are sent depending on the parameterization:
•
Status switch output A...C (provided that the communication object is enabled and parameterized as
on request)
•
Status contact monitoring (if parameterized as on request))
•
Status intermediate meter total (if Intermediate meter total is enabled)
•
Status intermediate meter output A...C (if the intermediate meter total output A...C is enabled)
•
Load limit exceeded (if function Load control master
enabled)
•
Status load control (if function Load control master enabled and Monitor load values cyclically is pa-
rameterized).
With the option yes, the following parameters appear:
Enable communication object
"Request instrument values" 1 bit
Options:
•
yes: A 1 bit communication object Request instrument values is enabled.
Via this communication object, all instrument values can be requested, provided that they have been pa-
rameterized with the option on request. These instrument values include:
•
Current
•
Voltage
•
Frequency
•
Power factor
•
Crest factor.
With the option yes, the following parameters appear:
Request with object value
Options:
0
1
0 or 1
•
0: Sending status messages is requested with the value 0.
•
1: Sending status messages is requested with the value 1.
•
0 or 1: Sending status messages is requested with the value 0 or 1.
no
yes
Request with object value
Options:
0
1
0 or 1
•
0: Sending status messages is requested with the value 0.
•
1: Sending status messages is requested with the value 1.
•
0 or 1: Sending status messages is requested with the value 0 or 1.
SE/S 3.16.1 | 2CDC 505 084 D0203 31