Dtmf Signals For The Sensor; Sensor Message - Siemens HiPath 1100 Programming Manual

Relay and sensor on the HiPath 1120
Step by step
ekk
feg
182

DTMF signals for the sensor

This setting specifies a number sequence that is con-
verted to DTMF signals and sent after a call is an-
swered. The number to be called must be specified in
"Number dialed by sensor activation" (Code 052).
The default configuration does not specify any number.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter the number sequence (up to 20 digits).
w
r
Press this key.
Initial status for programming mode.

Sensor message

After assigning a number, you can assign a message to
the sensor. This message will be transmitted to the as-
signed number when the sensor status is changed.
Required: Programming mode is activated (*95 31994)
and an EVM Module is installed.
w
Enter the programming code.
e f
or
Select a Message:
e
= Greeting 1
f
= Greeting 2
w
Initial status for programming mode.