Table of Contents
Advertisement
5. Electrical Connections
5.4 Battery Installation
1.
As described in Subsection 5.2, remove the front case and lay the main body of the
system on a flat surface with the inside rear view faced upward. When you lay down the
system, make sure to have at least two persons work together for safety.
2.
Prepare the battery tray to dock the battery on the main body and have at least the two
persons work together because the battery weighs much. The [Figure 5-7] shows the
battery tray seen from the enclosure. The knobs are located on the battery tray plate,
and the battery is located on the opposite side of the knob enclosure.
3.
As seen in the [Figure 5-8] of the battery tray, the output cable is connected with the
connector, and four BMS and the signal cables come out from the battery module.
28
[Figure 5-6: Rear Inside View]
[Figure 5-7: Battery Tray Rear View]
[Figure 5-8: Battery Connection]
Australia (Eng.) 05/2015. Rev1.1
Advertisement
Table of Contents
