Wheel Removal Procedure
1. Stop the engine, place the transmission in gear and lock the parking brake.
2. Loosen the wheel nuts slightly.
3. Elevate the side of the vehicle by placing a suitable stand under the footrest
frame. The stand must be sturdy enough to safely support the weight of the
ATV.
4. Remove the wheel nuts and remove the wheel.
Wheel Installation
1. With the transmission in gear and the parking brake locked, place the wheel in
the correct position on the wheel hub. Be sure the valve stem is toward the
outside and rotation arrows on the tire point toward correct rotation.
2. Attach the wheel nuts and finger tighten them.
3. Lower the vehicle to the ground.
4. Securely tighten the wheel nuts according to the specifications in the chart
below.
Bolt Size
Specification
Front
20Ft.Lbs
M10 X 1.25
Rear
50Ft.Lbs
M12 X 1.25
Tire Inspection &
Replacement
Always replace tires when tread
depth (1) is worn to 1/8˝ (3mm) or less.
When replacing tires always use
original equipment size and type. See
Section 21 "Specifications – Drive
System" for tire sizes.
27N.m
69N.m
70