Craftsman 108.27807 Operator's Manual page 46

4. After crossing, dry the brakes by applying light pressure to the lever until
braking action is normal.
NOTE: After running the vehicle in water, it is critical your machine is serviced as
outlined in the maintenance chart in Section 17 "Maintenance". The following
areas need special attention: engine oil, transmission oil, rear gear case, and all
grease fittings.
CAUTION
If your ATV becomes immersed or if water has been ingested into the CVT system,
take it to your dealer before starting the engine. Major engine damage can result if
the machine is not thoroughly inspected.
If it is impossible to take it to a dealer before starting, follow the steps below.
1. Move the ATV to dry land
or at the very least, to
water depth not more
than 8 inch (200mm).
2. Turn the fuel valve
selector to "OFF".
3. Remove the spark plug.
4. Loosen the carburetor
drain screw (1).
5. Turn the engine over
several times with electric
start.
6. Dry the spark plug and
reinstall or replace with a
new plug.
7. Tighten the carburetor drain screw (1).
8. Turn the fuel valve to "ON".
9. Attempt to start the engine. If necessary repeat the "drying" procedure.
10. Take the machine to your dealer for service as soon as possible whether you
succeed in starting it or not.
46