Craftsman 108.27807 Operator's Manual page 68

transmission oil reservoir.
2. Remove fill plug.
3. Remove the transmission drain plug located on the bottom left hand side and
drain the oil. Catch and discard used oil properly.
4. Clean and reinstall the drain plug torque to 14 ft.lbs. (20Nm)
5. Add the correct amount of SAE 80W/90GL5 Lubricant until oil reaches the
bottom of the filler hole
6. Check for leaks.
7. Reinstall foot well and screws removed in step 1. Reinstall fill plug.
Front/Rear Gear Case Lubrication
Checking the Level
1. ATV should be on level surface.
2. Remove fill plug (1) and visually inspect lubricant level. Lubricant should be
1-5/8" (41mm) below the top of the fill hole on the rear gear case and even with
the fill hole on the front gear case.
3. Reinstall fill plug. Tighten securely (14 ft.lbs/20N.m).
Changing the Oil
1. ATV should be on level surface.
2. Remove drain plug (3). Catch and discard used lubricant properly.
3. Clean and reinstall the drain plug with a new sealing washer (Reference parts
manual) and tighten securely (14 ft. lbs/20N.m).
4. Remove fill plug (1) and add 10 ounces (300ml) of gear lubricant to the rear
gear case, fill until full on the front gear case.
5. Reinstall the fill plug. Tighten securely (14 ft. lbs/20N.m).
6. Check for leaks.
NOTE: The correct gear case lubricant to use is SEA 80W/90 GL5 weight gear
lube.
68