White Balance Item - JVC GY-HM600U Instructions Manual

H Frequency
For specifying the correction frequency of the
horizontal contour. Set this according to the object.
High:
0
Emphasizes the high frequency range. Use this
when shooting objects with fine patterns.
Middle:
0
Emphasizes the intermediate frequency range.
Low:
0
Emphasizes the low frequency range. Use this
when shooting objects with large patterns.
[Setting Values: High, RMiddle, Low]
Memo :
When [System] under [Record Format] is set to
0
"SD", this item is fixed at "Low".
V Frequency
For specifying the correction frequency of the
vertical contour. Set this according to the object.
Low:
0
Emphasizes the low frequency range.
Middle:
0
Emphasizes the intermediate frequency range.
High:
0
Emphasizes the high frequency range.
[Setting Values: Low, RMiddle, High]
Memo :
When [System] under [Record Format] is set to
0
"SD", this item is fixed at "Low".
(A P112 [ Record Format ] )
"High" cannot be selected under the following
0
settings.
When [Resolution] is set to "1920x1080", and
0
[Frame & Bit Rate] is set to "60i(HQ)" or
"50i(HQ)".
When [Resolution] is set to "1440x1080", and
0
[Frame & Bit Rate] is set to "60i(HQ)",
"50i(HQ)", "60i(SP)" or "50i(SP)".
Skin Detail
For turning On/Off the Skin Detail function, which
is used to adjust the contour correction effect of the
colors captured.
Select "On" to soften the detail at areas where skin
tone is detected.
[Setting Values: On, ROff]
9 Level
For setting the level of contour correction (degree
of softening) using the Skin Detail function.
Decreasing the value increases the level of contour
correction (degree of softening).
[Setting Values: -1, R -2, -3]
9 Range
For adjusting the range of skin tone to trigger the
Skin Detail function.
Increasing the value increases the range.
[Setting Values: -5 to +5 (R0)]

White Balance Item

Preset Temp.
For setting the color temperature when the [WHT
BAL] switch is set to "PRESET".
For details, refer to "[Adjusting the White
Balance] P 57".
Alternative Temp.
For setting the alternative color temperature in the
Preset mode.
When the [WHT BAL] switch is set to "PRESET",
pressing the [y] button each time switches the
color temperature setting in the Preset mode.
([Preset Temp.] 1 [Alternative Temp.])
For details, refer to "[Adjusting the White
Balance] P 57".
101