Troubleshooting - Sanyo CDF-R800 Operating Instructions Manual

Troubleshooting
An error made in operation or an error during installation can be mistaken for a system
malfunction. Check below before contacting your Authorized SANYO Service Station.
Svmntom Cause Remedv
_#. .r. -
.
No power
The power wires are not connected Check the connections of the+ 12V
correctly.
Accessory / Ignition wire (Red) and
the + 12V Constant power supply
wire (Yellow).
Vo sound
The speakers are not wired correct- Check the speaker wiring connec-
Iy.
tions.
The volume level is too low. Increase the volume level. (See
page 8 "Audio control".)
A CD cannot There is another CD in the unit.
Eject the CD and then insert the
~e loaded.
next CD.
Transpori screw is still in place.
Remove a transport screw on the
top of unit. (See page 20 "Before
Wiring and Installation".)
The unit ejets
Transport screw is still in place.
Remove a transport screw on the
the CD.
top of unit. (See page 20 "Before
Wiring and Installation".)
Extremely dirty CD
Clean the CD. (See page 4 "Han-
dling the CDs".)
Extremely hot temperature
Open the window and allow the car
to cool.
Moisture condenses on the optical Wait for a while, until the condensa-
Iens.
tion evaporates.
Sound skip
Improper installation
Install the unit properly. (See page
while playing a
24 "installation".)
CD.
The CD is defective.
Compare the sound with another
CD. If the sound from the second
CD is acceptable, the first CD is
defective.
Dirty CD Clean the CD. (See page 4 "Han-
dling the CDs".)
Poor sound The CD is defective.
Compare the sound with another
while playing a
CD. If the sound from the second
CD.
CD is acceptable, the first CD is
defective.
Dirty CD Clean the CD. (See page 4 "Han-
dling the CDs".)
Moisture condenses on the optical
Eject the CD and wait for a while,
lens. until the condensation evaporates.
25