Sanyo CDF-R800 Operating Instructions Manual page 22

Wiring
. BeSureto turn
off the
ignition and
remove the negative (–) battery cable, prior to
wiring.
Note:
When you remove the negative (–) battery cable, all the equipments supplied by
the car battery (Clock, on-board drive or navigation computer, e.t.c.) may stop
working or lose their memory.
Connect the
power leads (Red and Yellow)
after all other connections have been
made.
. Be sure to locate the wiring away from the Shift lever, Hand brake, Seat rail, e.t.c.
. Keep the leads away from the areas subject to high temperatures, such as near
the heater outlets.
Speaker wiring
.
Be sure to observe the wiring polarity (+) and (–) to ensure that the speakers are
connected correctly.
. The impedance of the speakers should be 4-8 Q.
. Do not connect any speaker wires to the metal body or chassis of the vehicle.
Connect each speaker wire directly to each speaker terminal.
. Do not use the speaker wires supplied inside the vehicle unless you are sure that
there are separate positive and negative leads for each speaker.
Location for installation
Do not install the unit in the following locations :
. Where it may disturb driving
Where it may place the passenger in danger
. Where it interferes with the opening and closing of glove box or ash tray
. In dusty locations
. Near magnetic fields
. Where hot air is discharged from the car heater or where it is exposed to direct
sunlight
. Where rain can enter the unit, or where it may be exposed to high humidity
Installation of the unit
Mount the unit firmly in place to prevent shaking.
Inclination angle:
Install the unit as close to a horizontal position as possible. If the unit must be
inclined, the angle should be 30° or less.
Be sure to use the supplied accessories for installation.
. Do not use any of the screws that are part of the brake or steering system, to
install the unit.
. Be careful not to snag any wires.
. When drilling the dashboard, make sure there is nothing behind it beforehand.
When wiring and installation is finished
Make sure that all the electrical equipment (break lamps, lights, horn, flasher, wipers,
e.t.c.) operate normally.
21