Nokia 105s Installation Manual page 83

2. Loosen the two front panel retaining screws.
3. Slide the chassis tray assembly forward to expose the DIMM sockets.
Note
Because power to an 105s gateway is automatically disconnected when
the chassis tray assembly is opened, you do not need to manually
disconnect the power for this procedure. Any servicing of the unit,
however, should be completed with the chassis tray assembly fully
removed from the gateway. Power is still active in the chassis body and
care should be taken when working on the power supply or power supply
wiring without disconnecting the power cord.
4. Locate the battery on the motherboard.
Nokia 105s Gateway Installation Guide
To use the CLI to do this, enter halt at the prompt.
Remove the tray completely to avoid damaging components.
Chassis tray assembly retaining screws
Replacing the Battery
00525gen
83