Configuring And Activating Interfaces; Monitoring Network Interface Cards - Nokia 105s Installation Manual

11. Tighten the retaining screws that hold the chassis tray assembly.

Configuring and Activating Interfaces

The 105s gateway automatically detects any new NIC when the gateway is
restarted. Use Network Voyager to configure and activate the logical and
physical interfaces on the NIC.
For information about how to access Network Voyager and the related
reference materials, see

Monitoring Network Interface Cards

You can asses the general operating condition of the NICs in your gateway by
looking at the LED status indicators on the NICs. The status indicators for
each NIC are explained in the NIC reference chapter.
For status indicator information for the built-in Gigabit Ethernet ports, see
"Built-In Gigabit Ethernet Ports"
For status indicator information for the four-port Ethernet NIC, see
Port 10/100 Mbps Ethernet NICs"
For status indicator information for the two-port copper Gigabit Ethernet NIC,
see "Two-Port Copper Gigabit Ethernet Network Interface Card"
Nokia 105s Gateway Installation Guide
Chassis tray assembly retaining screws
"Using Nokia Network Voyager"
on page 21.
on page 59.
Configuring and Activating Interfaces
on page 43.
00525gen
"Four-
on page 63.
57