Sanyo ASW U1100T Service Manual page 18

TROUBLE
d. Drain
Water does not
drain out
Drain takes time
too long
1m max (extension)
e. Spin Drying
Spin drying cycle
does not work
NOTE :
1. When Safety Switch is continuously
affected 3 times, the washer will adjust
the unbalance condition. If the washer
can not adjust the unbalance condition,
it will stop and indicator shows U3 by
flashing on and off.
INSPECTION
Is the Magnetic coil
working normally ?
No
Extension of the Drain Hose:
The maximum length and height to which the
Drain Hose can be extended are given below.
Does safety device
work ?
No
CAUSES
Yes
Foreign matter in Valve
Valve Spring is deformed
Valve Bellows is
deformed
Magnetic Coil lead wire
is disconnected.
P.C.B Complete is
defective
Valve Bellow is deformed
Connect Hose is deformed
Drain Hose Ass y is
deformed
Extension hose is too
long or too high.
Yes
Machine inclines
The V-belt is slipping
V-belt is snapped
Motor Pulley mounting
screw is loose.
Motor is disconnected or
burnt
Capacitor is defective or
disconnected
Bearing Ass y is
defective
Magnetic Coil is defective
Brake Lever is defective
Thermostat on motor is
opened
Poor connection of the 14
pin connectors
P.C.B Complete is
defective
- 17 -
REMEDY
Clean valve inside
Replace Valve Spring
Replace Valve Bellow
or replace Valve
Spring
Repair or replace
Replace
Replace
Repair or replace
Repair
Repair
Extension hose height Extension hose lenght
15 cm max 1m max
- - 3m max
Adjust the adjustor of
leg
Adjust the motor
position
Replace
Tighten up
Repair or replace
Repair or replace
Replace
Replace
Replace
Repair or replace
after cooling down
Repair or replace
Replace