Sanyo ASW U1100T Service Manual page 15

Replacement of Suspension Rod Ass y:
(1) Remove the screws which are seemed on Top plate, follow the steps of Replacing top plate .
(2) Lay the washer down left or right suitably on the floor (It is necessary to have a soft cloth or blanket to
protect the washer).
(3) Remove the Top Plate.
(4) From bottom of Outer Tub, push the Suspension Rod Ass y up until it raises from suspension base.
(5) After removing the Stopping Pin, pull out the Suspension Rod Ass y from bottom of Frame.
(6) Follow the steps above in the reverse order when you want to assemble them again with a new
Suspension Rod Ass y.
When you have to replace a suspension rod complete, please replace the all of four Suspension Rod
Assembly.
There are four types of Suspension Rod Complete:
At the motor side:
1 Set (Service Code: 617-259-7195)
At the motor side:
(In the corner of front side and left side)
1 Set (Service Code: 617-259-7119)
Lead Wire connector for water supply Valve
(1) Move the insulation tube.
(2) To remove the connector from water supply
valve, pull it while pressing the Projection in the
middle with your nail to unlock.
Do not pull it by force without unlocking,
otherwise the Lead Wire may be torn off.
When reconnecting the Connector, make sure
that it is locked firmly by pulling it slightly after
connecting.
(3) Fix the Insulation Tube.
Back
Left
Motor
Front
- 14 -
At the non- motor side:
1 Set (Service Code: 617-259-7188)
Right
At the non- motor side:
(In the corner of front side and right side)
1 Set (Service Code: 617-259-7102)
Projection
Insulation Tube
Lead Wire
Connector