Table of Contents
Advertisement
9
9.4.1
Procedure for Scanning to a Server
9.4.1.1 Using the Auto Document Feeder
1
Press the [Scan] key.
The copier switches to Scan mode,
and the scan screen appears.
2
Place the document to be scanned
in the auto document feeder.
H
Adjust the guides to the size of
the document.
H
Load the document with the
surface to be scanned face up.
3
Press the [Speed Dial] key, and
then use the 10-key pad to enter the
3-digit speed dial number
programmed with the FTP server
address where you want to upload
the scan data.
H
Specify a speed dial number
between "201" and "210".
H
An FTP server address can only
be specified with a speed dial number. In addition, the FTP server
addresses are registered for a speed dial number using Power
Web Management Utility. For details, refer to "Specifying the
Settings for Speed Dialing" on page 9-48.
H
If you make a mistake, press the [No] key, and then enter the
correct number.
H
If there is no address registered for the specified speed dial
number, an error message appears. Enter a correct speed dial
number.
4
Press the [Yes] key.
H
To skip specifying the image
resolution, press the [Start] key
instead of the [Yes] key.
9-68
9.4 Using Scan to Server (FTP) Operations
Advertisement
Table of Contents
