Table of Contents
Advertisement
9.1 Overview
H
SMTP settings
H
POP3 settings
H
FTP settings
G
Adding/changing e-mail addresses
H
One-touch dial settings
H
Speed dial settings
H
Group dial settings
H
Speed dial settings (adding an FTP server address)
9.1.6.2 System Requirements
Power Web Management Utility can be used in the following system
environments.
Operating system
Browser
9.1.6.3 Accessing Power Web Management Utility
Note
In order to use Power Web Management Utility, an IP address, subnet
mask, and gateway setting must already be specified from the control
panel of the copier. For information on specifying these settings, refer
to "Network Settings" on page 9-21.
Power Web Management Utility is accessed directly using a Web
browser.
1
Start up your Web browser.
2
Enter the IP address of the copier into the "Address" box, and then
press the [Enter] key.
http://<copier_IP_address>/
H
(Example) If the copier IP address is 192.168.0.100, enter:
http://192.168.0.100/
3
The Power Web Management Utility screen appears.
9.1.6.4 Using Power Web Management Utility
Power Web Management Utility is used in the same way as other Internet
Web pages. Click links in the page to jump to that page, and use the
Windows 98 SE, Windows 2000, or Windows
XP
Microsoft Internet Explorer 4.0 or later
Netscape Navigator 4 or later
9
9-11
Advertisement
Table of Contents
