Table of Contents
Advertisement
Troubleshooting
Before requesting service, check the points listed below. If the problem persists, contact your supplier.
Starting up
Symptom
Power does not come on.
Power gets turned off
automatically.
Operation
Symptom
Cover cannot be opened.
Key cannot be removed from
lock.
SDHC Memory Card slot
cover cannot be closed.
The recorder does not
respond or another problem
has occurred.
Recorder was restarted
without performing a reset.
• Check whether power cable (included in the sold separately Cable Kit) is connected
correctly.
• If you have set a refer to "PowerOff Time" on page 81 and are running the recorder with
the ignition switch at LOCK (OFF), turn the ignition switch on and reboot the recorder
(see "Rebooting This Unit" on page 76).
• If the operating environment is hotter than the recommended temperature, the recorder
may turn off for safety reasons. If this happens, wait for the operating environment to
cool down before using the unit.
• Are you using the supplied key?
• Is the SDHC Memory Card slot cover closed? The key can only be removed if the SDHC
Memory Card slot cover is closed.
• Is an SDHC Memory Card inserted correctly in an SDHC Memory Card slot?
• To reset the recorder, keep pressing the [REC] button and [STOP] button on the recorder
together for about 10 seconds. When resetting, after all lamps turn off (1 or seconds)
and then on (1 or seconds), all lamps blink.
• If the button lock is enabled ("ANY" or "STOP"), change the setting to "OFF" (see
"Operation Key Lock" on page 89).
• If you remove the SDHC Memory Card during SDHC Memory Card access ([BUSY] lamp
is lit), the SDHC Memory Card slot may become inoperative. In such a case, the recorder
automatically restarts itself, and the card slot will become operative again.
109
Remedy
Remedy
Hide quick links:
Advertisement
Table of Contents
