Throttle Linkage Adjustment (Fig. 15)
1. Loosen the capscrew and nut securing the throttle
cable to throttle lever.
2. Push the governor lever all the way back so it is
contacting the high speed set screw.
3. Move the throttle lever to the maximum speed posi-
tion (all the way forward).
4. Tighten the cap screw and nut securing the throttle
cable to the governor lever.
5. Make sure the throttle cable conduit does not interfere
with the full range of motion of the throttle lever or
governor lever.
Troubleshooting
Giving Immediate attention to any indication of a prob-
lem can prevent major failures, and increase the life of
the engine.
®
Groundsmaster
300 Series
1. Governor lever
2. Cap screw and nut
3. Throttle lever
Never make more that one adjustment at a time, then
locate the trouble by a process of elimination. Remem-
ber the cause is usually SIMPLE, rather than mysterious
and complicated.
Page 4 - 15
Figure 15
4. Throttle cable
5. Throttle cable conduit
Troubleshooting