Pto Brake Adjustment - Toro Groundsmaster 300 Series Service Manual

PTO Brake Adjustment (Fig. 8)
1 . Lower the implement to the shop floor, turn the engine
off, remove the key from the ignition switch, and engage
the parking brake.
2. Move the P.T.O. lever to the ENGAGE position.
Loosen the adjusting locknut so that the brake is free to
move. Then move the P.T.O. lever to OFF and position
the brake in the grooves of the pulley.
3. Tighten the locknut until the spacer contacts the side
of the brake bracket.
Figure 8
®
Adjustments Page 9 - 6 Groundsmaster 300 Series