Lcd Circuit Board And Lcd - Yamaha 01v 96 Service Manual

<Top view>
Fader knob
Photo.15
13.

LCD Circuit Board and LCD

(Time required: About 20 minutes)
13-1. Fasten the control panel assembly. (See procedure 1.)
13-2. Remove the ADA circuit board. (See procedure 10.)
13-3. Remove the HA circuit board. (See procedure 11.)
13-4. Remove the six (6) screws marked [190A]. The HA-
ADA angle, PN1 shield plate 1 and 2 can then be
removed. (Photo.17)
13-5. Remove the five (5) screws marked [80]. The LCD
circuit board can then be removed. (Photo.18)
13-6. Remove the two (2) screws marked [100] and the
two (2) screws marked [190B]. The LCD shield plate
can then be removed. (Photo.19)
13-7. Remove the four (4) screws marked [60]. The LCD
can then be removed. (Photo.20)
<Bottom view>
[190A]
[190A]
PN1 shield plate 2
PN1 shield plate 1
[190A]: Bind Head Tapping Screw-B
3.0X8 MFZN2BL (EP600190)
Photo.17
LCD
[190A]
HA-ADA angle
<Bottom view>
Insulation sheet
FD
Cord holder
[210]
[210]: Bind Head Tapping Screw-B
3.0X8 MFZN2BL (EP600190)
Photo.16
<Bottom view>
LCD
[80]
[80]: Bind Head Tapping Screw-B
3.0X8 MFZN2BL (EP600190)
Photo.18
01V96
[210]
Cord holder
29