Kenwood KDC-PSW9527 Instruction Manual page 59

Connector Function Guide
Pin Numbers for Cable Colour
ISO Connectors
External Power
Connector
A-4 Yellow
A-5 Blue/White
A-6 Orange/White
A-7 Red
A-8 Black
Speaker
Connector
B-1 Purple
B-2 Purple/Black
B-3 Gray
B-4 Gray/Black
B-5 White
B-6 White/Black
B-7 Green
B-8 Green/Black
2WARNING
Functions
Connecting the ISO Connector
The pin arrangement for the ISO connectors depends
on the type of vehicle you drive. Make sure to make the
proper connections to prevent damage to the unit.
Battery
The default connection for the wiring harness is described
Power Control
in 1 below. If the ISO connector pins are set as described
Dimmer
in 2 or 3, make the connection as illustrated.
Ignition (ACC)
Please be sure to reconnect the cable as shown 2 below
Earth (Ground)
Connection
to install this unit to the Volkswagen vehicles etc.
1 (Default setting) The A-7 pin (red) of the vehicle's
Rear Right (+)
ISO connector is linked with the ignition, and
Rear Right (–)
the A-4 pin (yellow) is connected to the constant
Front Right (+)
power supply.
Front Right (–)
Front Left (+)
Front Left (–)
Unit
Rear Left (+)
Rear Left (–)
Battery cable (Yellow)
2 The A-7 pin (red) of the vehicle's ISO connector
is connected to the constant power supply, and
the A-4 pin (yellow) is linked to the ignition.
Unit
3 The A-4 pin (yellow) of the vehicle's ISO
connector is not connected to anything, while
the A-7 pin (red) is connected to the constant
power supply (or both the A-7 (red) and A-4
(yellow) pins are connected to the constant
power supply).
Unit
Ignition cable (Red)
Ignition cable
(Red)
Battery cable
(Yellow)
Ignition cable
(Red)
Connect to a power source
that can be turned on and
Battery cable
off with the ignition key.
(Yellow)
A-7 Pin (Red)
Vehicle
A-4 Pin (Yellow)
A-7 Pin (Red)
Vehicle
A-4 Pin (Yellow)
A-7 Pin (Red)
Vehicle
59
|
English