Toro Greensmaster
Flex 18 04018 Service Manual page 95

Assembly (Fig. 34)
1. On RH side plate, if inner retaining ring (item 24) was
removed, install inner retaining ring. Insert thrust wash-
er (item 3) and then wave washer (item 20) into the side
plate.
2. On LH side plate, insert o–ring (item 17) into groove
in side plate. Make sure that o–ring is not twisted and is
seated in side plate groove. Apply a light coating of
grease onto the o–ring and side plate bore.
3. Pack bearing (item 18) with Mobil High Temperature
XHP–222 grease (or equivalent). Press bearing into the
side plate.
4. On RH side plate, install outer retaining ring (item 24)
into side plate groove.
5. Pack the inner cavity of seals (item 16) with Mobil
High Temperature XHP–222 grease (or equivalent).
Also, fill side plate cavity between installed bearing and
both seal locations 75% to 95% full with Mobil High Tem-
perature XHP–222 grease (or equivalent) (Fig. 35).
6. Press grease packed inner and outer seals into the
side plate until seals are flush with the surface of the side
plate bore. Seal lips of both inner and outer seals should
be toward the bearing.
7. Install side plate(s) to cutting unit (see Cutting Reel
Installation in this section).
Greensmaster Flex 18/21
FILL 75% TO 95% WITH
MOBIL HIGH TEMP
XHP–222 GREASE
GREASE SEAL
TO BE FLUSH
RH SIDE PLATE
SHOWN
Page 7 – 25
FILL 75% TO 95% WITH
MOBIL HIGH TEMP
XHP–222 GREASE
GREASE SEAL
TO BE FLUSH
PACK WITH
MOBIL HIGH TEMP
XHP–222 GREASE
Figure 35
Cutting Unit